Old Parts from the 88 Iroc

[IROCZ355]

I've got quite a few things that I need to get rid of:

-Parts from my old 350 before the crank bearing started tapping(Crane Cams Stuff) all roller with about 40k miles on them:
1.5 roller rockers, heat treated pushrods, hydraulic roller lifters, PowerMax Emission Legal Cam adv 270/276 .440/.454 (I think)

-Origional Stall Converter for 700r-4

-stock exh. manifolds w/ AIR provisions...with stock y-pipe

-origional 9 bolt rear end w/ 2.77 gears,disc brakes and a lovely bearing hum at higher speeds!

Will have soon when ever my stealth ram comes in off back order:

-Stock TPI set up w/ 22lb injectors but no throttle body or sensors.

-Nice chrome strut tower brace that I hate to see go.

Make me a reasonable offer on anything because they all must go. It's spring cleaning time and I could use the extra room. Either respond or call 774-696-4384.

[IROCZ355]

Camon I know somebody must want something...Cheap Cheap stuff! :thumbsup:

[MENTL231]

How much for the rear? Will you sell just the disc set up?

[lunatic_magnet]

which style disc rear is it, iron calipers or aluminum (PBR)?

[IROCZ355]

They're the iron calipers but the whole thing must go.

[lunatic_magnet]

a humming 9 bolt...eeccch. at least if it had the good brakes it would be worth getting the aluminum caliper setup off em.

how about the strut tower brace? who make it, is it the Jamex thing, or is it a 3 point one like edelbrock?

[white91formula]

i might be interested in the strut tower brace if it is a 3 point one like hte edelbrok if lunatic does not get it

[IROCZ355]

no it's a one crome tube bar that runs from each tower. Looks sharp on a motor with chrome already on it.

[white91formula]

got a pic ?

[lunatic_magnet]

i'd like to see some pics too, or at least if you could give me a manufacturer...